#Home start position vectric vcarve pro how to
#Home start position vectric vcarve pro driver
#Home start position vectric vcarve pro software

The field width is usually set to вЂњ1вЂќ a value greater than 1 is typically only required if a controller expects to see a fixed number of characters for the value. The format flags are optional and only needed by a small number of controllers they will be described shortly.ДЇield Width The Field width represents the minimum number of characters that are output. The values format string should be formatted as follows:ДЇORMAT_FLAGS FIELD_WIDTH DECIMAL_SEPARATOR DECIMAL_PLACES Name of the product used to output file, including version number. List of toolpaths used in file (in order of use). Z Zero Position, Table or Material Surface. Mid-point of arc in Y (incremental coordinates).Дiameter of cylinder that axis is wrapped around. Mid-point of arc in X (incremental coordinates). Mid-point of arc in Y (absolute coordinates). Mid-point of arc in X (absolute coordinates). Text from Note field in ToolDB for current toolДЇilename (Produced by вЂњSave Toolpath(s)вЂќ).Д¬urrent coordinate of tool position in X axis.Д¬urrent coordinate of tool position in Y axis.Д¬urrent coordinate of tool position in Z axis.Д¬urrent coordinate of tool position in A axis.ДЄrc centre in X Axis (relative to last X,Y position).ДЄrc centre in Y Axis (relative to last X,Y position).ДЄrc centre in X Axis (absolute coordinates).ДЄrc centre in Y Axis (absolute coordinates). For an example, see the file: Roland_MDX-40_mm.ppД¬urrent power setting for jet-based tools (e.g.

Spindle speed for this machine is output as a range of integer numbers between 1 and 15 representing the actual speed in RPM of the spindle, (between 450 RPM in the quoted example). The moves in the X axis are to be wrapped around a cylinder of the specified diameter. The moves in the Y axis are to be wrapped around a cylinder of the specified diameter.

#Home start position vectric vcarve pro software

The control software uses a document interface that can directly accept the NC file output. Indicates that plunge moves to Plunge (Z2) height (that is set on the material setup form) are rapid movesДIRECT_OUTPUT='Display Name|Manufacturers.Document'

#Home start position vectric vcarve pro driver

The machine tool manufacturer has supplied a driver (usually a printer driver) thatn can directly accept the NC file output (For example see Generic HPCL_Arcs.pp)

The units that the file outputs (INCHES or MM) The file extension that the file will be given The name that will appear in the post processor list The Vectric post processor uses simple text based configuration files, to enable the user to tailor a configuration file, should they wish to do so. Machine controller manufacturers will often customize the file format required for programs to run on a particular machine in order to optimize the control to suit the individual characteristics of that machine.

#Home start position vectric vcarve pro how to

This document details how to create and edit the configuration files that customize the output from the program to suit a particular machine control.Д«elow are sections of a typical program that has been post processed into both G-Code and HPGL The post processor is the section of the program that converts the XYZ coordinates for the tool moves into a format that is suitable for a particular router or machine tool.